Quote:
Originally Posted by robotoid
Yes, I have one on my 640-1. The only thing is when drilling the new sight, you have to be careful not to over enlarge the pin hole in the barrel. You need a wire gauge drill bit size #54 or #55. It's so small I had to chuck it in my Dremel at low speed. If you are doing a 340, be aware the barrel shroud is very soft aluminum and you can easily oval out the pin holes if you don't hold the drill perfectly. Drill from both sides and meet in the middle, don't try to go straight thru. Tape the sides of the barrel too in case you slip (I did).
|
Sir,
Just had the HiVez professionally installed by a master smith. Now that I have it, I am shooting all over the place.
Can you tell me how to align it so I can hit a paper plate at 7 yards? Tell me exactly how to align it with the two back sights?
I would greatly appreciate it. I know I am not using the proper nomenclature so please be kind!!! LOL!!
Thanks a lot!
rd