Look at
Laser Ammo. They have a nice line of laser bullets, targets, etc. I use their laser bullets and targets.
Their bullet and Laserlyte target should work as the laser freq and power are compatible. However I would talk to them to verify.
They have a standard backcap and also one that doubles as a boresight.
"
I'll also use this to align up my sites via holding down the trigger." I am not sure how that would work. The firing pin hits the cartridge and withdrawals. The boresight backcap will turn on the laser on the 1st trigger pull and then it off on the next.
Their 45ACP adapter will not clip into moon clips. However it will work w/o being in a moon clip. I am using one in my 325 Thunder Ranch.
I tried the
Laserlyte Trainer Pistol Premium - LT-PRE laser bullet in one of my revolvers. The laser fired off OK. However I could never get the laser bullet to fit into the front of the barrel right. It was either too loose or too tight. Lastly, the elevation adjustment did allow me to get it sighted in. The laser was always too low even at max elevation. However the Laserlyte bullet did work with my Laser Ammo Pet target.
One last thing is sighting with my Laser Ammo. I find that where the laser hits is not where I am sighted. It is consistent but is off. In looking at the GSight laser bullets, I see they have 2 O rings. This might help make sure the bullet sit properly. The Laser Ammo bullets do not have any O rings.
Let us know how you make out. I am interested.