Ok, this job is getting the better of me, and a big hammer is looking seductive right now.
I have taken the old sight out, that was easy, and that is the point where all the installation guides stop.
Nobody talks about how to get the new sight IN!
I am trying to install a hi-viz, and the sight is too long to try and catch the base on the plunger, but if I use a tool to push the plunger in, then I cannot catch the end of the base around the end of the plunger because the tool is in the way.
Everyone says this job is easy, so I must be missing something. So any help, or any videos would be greatly appreciated.