Smith & Wesson Forum

Go Back   Smith & Wesson Forum > >

Notices

S&W Revolvers: 1980 to the Present All NON-PINNED Barrels, the L-Frames, and the New Era Revolvers


Reply
 
Thread Tools Display Modes
  #1  
Old 02-12-2020, 04:42 PM
American1776's Avatar
American1776 American1776 is offline
Member
model 69 question on endshake model 69 question on endshake model 69 question on endshake model 69 question on endshake model 69 question on endshake  
Join Date: Jan 2014
Posts: 1,621
Likes: 2,940
Liked 3,518 Times in 949 Posts
Default model 69 question on endshake

My model 69 came from the factory with more endshake than normal. True b/c gap is .005 and with the cylinder forward I cannot comfortably fit a .002 gauge inside the gap.

I'm going to order some power custom endshake bearings. I'd like to know if the 69 takes the normal bearings, since this model has had the yoke tube redesigned.


Thanks.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Model 57 Yoke Endshake - Shims or Peening to fix? UnderDawgAl S&W-Smithing 5 10-28-2018 01:22 PM
Yes, another CG/endshake question RIDE-RED 350r S&W Revolvers: 1980 to the Present 22 11-23-2014 09:44 AM
Model 19-3 Endshake? TBalls S&W Revolvers: 1961 to 1980 8 01-12-2012 11:50 PM
endshake question Mark4 S&W-Smithing 6 03-02-2011 01:01 PM
Model 27 Endshake Bushings WallyL S&W-Smithing 2 08-05-2010 02:28 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 05:52 PM.


Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)