Would like to relieve the frame on the bottom of the trigger guard on my M&P 40C.

I've seen guys ruin guns with Dremel tools so I thougt I'd ask first.

Any suggestions?

I've done this on my Glock with a round file & sandpaper & you can't hardly tell by looking but it feels so much better to my hands..
I finished up with 1500 grit & it's actualy smoother than the frame was originaly, then I rubbed it with Armoural Interior..
Here's a pic were you can see that near the frame it's relieved..
Gary/Hk

__________________
MightShowYouHisSmith&Wesson

The only downside I could see is if you had a frame problem you probably voided the warrenty.