|
|
10-17-2011, 06:43 PM
|
US Veteran
|
|
|
Join Date: Oct 2010
Location: WV
Posts: 62
Likes: 0
Liked 3 Times in 3 Posts
|
|
Nickel Finish Repair
I have a S&W Model 38 with a Nickel Finish. It has one small chip on the finish. It there an easy way to repair the chip or something that can be done to prevent the chip from becoming any larger?
|
10-17-2011, 08:05 PM
|
Member
|
|
|
Join Date: May 2001
Posts: 1,421
Likes: 0
Liked 947 Times in 413 Posts
|
|
Sorry, once chipped, scratched, or otherwise damaged, there's nothing you can do.
There's no way to "fix" a chip, and all you can do to is to keep a light coat of lube or wax on it to prevent moisture from infiltrating under the nickel and rusting the steel.
As long as you don't hit the area it shouldn't flake off or spread.
For wax use Johnson's Paste Wax or Renaissance Hard Carnuba.... NO CAR WAX.
|
10-20-2011, 05:18 AM
|
|
Member
|
|
|
Join Date: Apr 2006
Posts: 17,800
Likes: 7,843
Liked 25,709 Times in 8,687 Posts
|
|
I have had some success with using a polishing wheel on a Dremel with some Flitz to brighten up the chipped area. If you polish the steel well enough it will get bright and smooth enough that it is almost indistinguishable from the Nickel. You do have to be careful do not burn or chip the guns finish any more than it is now. I just did this on my inherited M36 (1951) Chief's Special with excellent results. The Nickeled screws were quite bunged up, and chipped. After trying hopelessly to buy new Nickel screws for months, I gave up! I used a small peening hammer to reshape and repair the screw heads, a set of jewelers files and Arkansas stones to re-cut the slot and make them round again. After I was satisfied with that, I highly polished them with Flitz and a Dremel and they look just like the Nickel finish. Just go slow and have a lot of patience, and you be OK.
Regards,
Chief38
|
10-20-2011, 10:27 AM
|
Absent Comrade
|
|
|
Join Date: Aug 2006
Location: Ardmore, OK
Posts: 791
Likes: 781
Liked 2,433 Times in 363 Posts
|
|
Spot plating does exist but whether it is adviseable for the described condition I don't have that kind of experience with it. Texas Plater Supply sells a kit that does electroplating with a brush, a chemical paste and a 6 volt DC power source which can be flashlite batteries. I have used their product at least 25 years, as recentlly as maybe two years ago. I have plated several complete guns and have touched up worn areas on many others.
If a chip has flaked off a gun I think the procedure would be to spot buff the area to blend the existing plating with the steel of the gun, degrease/clean the area and do the brush job. Without good prep, at best it would look like a nickel patch.
If you are comfortable with the work and/or willing to build up some experience on scrap it could work for you.
|
|
Posting Rules
|
|
|
|
|
All times are GMT -4. The time now is 07:02 PM.