Well, this is my venture into MIM parts revolvers. All my others are older and pre MIM. This is a relatively new acquisition.

Needless to say, the trigger/hand go together WAY differently.

I was disassembling the last of the parts, gave the assembly a good look, then removed the hand. Well the hand spring launched but I found easily (note to self buy lotto ticket). Anyway I can't figure out how it goes back together and... I wonder if I am missing another small part that may be part of the assembly that launched into the inner abyss of the garage.

Any help insight would be greatly appreciated.

That's one of those I'll NEVER do again.

If you look at the top of this section you will find the FAQ's by 500 MagnumNut. Click on the FAQ's and scroll through the posts. There you will find a picture of the trigger hand assembly for the MIM parts.
Many thanks to 500 MagnumNut.

Bruce

Thanks Bruce.

I was searching all the wrong terms and didn't get any hits.

Now to get it back together.

Your very welcome. All the credit goes to 500 Magnum Nut.
Everyone should check his posts for answers to common smithing questions.

Bruce