Picked up a shooter 1902 1st change target model and it is missing the spring and ball detent that assist in holding the cylinder open. Anyone know where I can look at a drawing/photograph to see what this might look like so I can try and make it?
thanks,
Stu

easy one, find a drill bit that fits the hole, cut off to 1/2 inch length , round over the end, grab a disposable lighter, rip it apart. the spring the pushes the flint up is the perfect diameter, just clip it to length.. insert into the hole, follow with drill rod and reassemble..

kritter, YOU DA' MAN.........Exactly what I was looking for. Thank you SO much.

Stu