i have a 908.. when i rack to put bullet in chamber... then release the magazine.. the top bullet in the mag. comes out of the mag falling on to the floor or in my hand... any idea whats going on.. this is a lnib pistol... any idea whats going on... thanks in advanced..

This is usually due to a rough surface on the "feeding rail, or "disconnector rail" on the bottom of the slide. The top round in the magazine, the one under the feeding round that ends up on the floor, gets "dragged" forward by the slide during the closing (feeding) sequence. As a result of being moved forward the round is extended slightly forward out of the magazine tube, and catches on the frame when the magazine is removed.

A little bit of careful, light polishing along the lower flat of the rail, and some light lubricant, or moly on the location will usually take care of the problem. Some of the slides have a very rough surface at the flat area indicated in the photos, including machine marks. See attached photos for the location to lightly polish.......

Attached Images

	IMG_0595b.jpg (93.5 KB, 41 views)
	IMG_0595a.jpg (101.4 KB, 41 views)

__________________
Ret. LE, FA Instr, S&W Armorer

Thanks... I sorta thought it might be a lube problem.. but did know exactly where to look... thanks for the awesome pics.. I will work on this and let u know the results

Replace your magazine spring. It's not unusual for the top cartridge to be slid forward, but there is usually enough tension to keep it in the magazine.

finally got around to do this... worked great... thank you