Hey guys, new member here to the forum. So, i have an issue with an apex trigger install and duty enhancement kit. My full size M&P9 has a manual ambidextrous thumb safety on it, and as of completion of the parts, I noticed a issue.
The firearm releases the striker with the safety engaged. Allow me to add that I did not install the striker block as i was unable to remove the rear sight. I was forced to skip this step due to the sight being stuck. I installed the the plunger spring, the sear, the trigger reset spring and the trigger itself. The trigger is smooth and VERY light, almost too light for comfort. I could sneeze and it would go off.
When tapping in the roll pins for the rear sear housing, it looks like i may have bent the safety lever, i requested a replacement from Smith & Wesson this morning hoping this relieves the issue, but my certainty is not 100%.
Would reinstalling the factory sear and plunger spring reverse this? Will i still get the benefits of the Apex trigger if i swap these parts? Or, am i going to get the same sloppy trigger pull as stock with a $164 aesthetic appealing only trigger?
Some help would be appreciated, looking forward to replies.