I recently picked up a 64-2 with the intention of making it a carry gun. I was originally going to look for a factory bobbed hammer, but the action is so nice on this gun as is, that I would rather bob the one that came with it.
That said, I have never cut a stainless hammer (it is stainless and non flash-chrome, right?). Once I cut it, can I replicate the factory surface finish easily or not? If so, what would you recommend?
I ask this because the case colored ones are easy: just some cold blue and it is usually good enough.
And if you think I am retarded and should just find a factory bobbed hammer to fit, I am always open to criticism.
Thanks!