|
|
07-29-2018, 12:05 PM
|
Member
|
|
|
Join Date: Jan 2008
Location: Florida
Posts: 148
Likes: 22
Liked 15 Times in 12 Posts
|
|
S&W 13 cylinder binds
S&W 13 when shooting 38 spl on the six round cylinder binds. Cylinder hard to open after this takes place
|
07-29-2018, 12:13 PM
|
Banned
|
|
|
Join Date: Jun 2018
Posts: 111
Likes: 13
Liked 72 Times in 42 Posts
|
|
I would be very concerned about carbon build up on the edge of the forcing cone. Sounds like a very dirty gun that needs the attention of a gunsmith.
|
07-29-2018, 12:15 PM
|
Member
|
|
|
Join Date: Nov 2005
Location: VA
Posts: 4,678
Likes: 1,449
Liked 4,519 Times in 1,935 Posts
|
|
Sounds like bent yoke or excessive end shake
|
07-29-2018, 12:47 PM
|
Member
|
|
|
Join Date: Aug 2008
Posts: 207
Likes: 216
Liked 138 Times in 76 Posts
|
|
Dirt under extractor?
|
07-31-2018, 08:59 PM
|
|
Member
|
|
|
Join Date: Jul 2006
Location: New Mexico & Arizona
Posts: 1,630
Likes: 735
Liked 1,460 Times in 644 Posts
|
|
Are you shooting reloads? Does your M13 have recessed cylinder?
Maybe high primers. Dirty cylinder recess and cartridges not seating properly.
Sent from my BNTV450 using Tapatalk
__________________
Support your Police, & NRA
|
08-01-2018, 12:15 AM
|
|
US Veteran
|
|
|
Join Date: Feb 2017
Location: Wisconsin
Posts: 816
Likes: 1,123
Liked 1,549 Times in 556 Posts
|
|
It could be as simple as the ejector rod loosening up. With the cylinder closed, try turning the rod with just your fingers. If it turns easily, there's your problem. It happened to me Sunday while giving my M58 a workout with some pretty stout loads.
|
08-01-2018, 04:13 AM
|
|
US Veteran
|
|
|
Join Date: Oct 2013
Location: Central Montana
Posts: 13,719
Likes: 12,860
Liked 39,491 Times in 10,051 Posts
|
|
Is the gun clean, especially under ejector star?
Is the Ejector rod tight? Left hand thread.
Is it straight? With cylinder part way open turn cylinder and observe looking down at it beside barrel.
How much gap measured With feeler gauges from barrel to cylinder face with cylinder pressed back? .004 minimum
Is it the same in all cylinder locations?
With empty brass in gun does it cycle through entire cylinder OK?
How about completely empty dry firing?
What do your primers look like. Anything protruding out of them after firing,?
Any drag marks on case heads?
|
|
Posting Rules
|
|
|
|
|
All times are GMT -4. The time now is 03:33 PM.