I am assembling a Victory model revolver, literally from a box of parts I acquired. Something to do as a winter project.
The barrel was previously on the frame, so I am optimistic it will fit without tweaking, but don't know for sure. The barrel screws in nicely up to about the last 1/4 turn, and alignment with the cylinder / frame looks good so far.
I fabricated by own frame / barrel wrench, but it is not holding sufficiently and I don't want to damage the frame by using a faulty tool.
Just wanted to ask if anyone has a K-Frame / Barrel wrench tool I could borrow; I'd pay shipping both ways. The cost of buying one is somewhat prohibitive for the scale of my project. I may seek out a professional gunsmith as a last resort.
Suggestions, comments welcome. Thank you!