|
|
08-01-2020, 04:42 PM
|
Member
|
|
|
Join Date: Nov 2012
Posts: 3
Likes: 0
Liked 2 Times in 2 Posts
|
|
Yoke Face (Facing) Reamer
Does anyone know of a current source for the S&W K,L or N frame yoke facing reamer?
|
The Following User Likes This Post:
|
|
08-01-2020, 05:26 PM
|
|
Member
|
|
|
Join Date: Jul 2004
Posts: 375
Likes: 553
Liked 344 Times in 140 Posts
|
|
|
The Following User Likes This Post:
|
|
08-01-2020, 11:35 PM
|
Member
|
|
|
Join Date: Nov 2006
Posts: 505
Likes: 18
Liked 111 Times in 59 Posts
|
|
Brownells sells that tool. You may need to also get their yoke barrel reamer. Many times that yoke barrel needs to be reamed in order for the pilot portion of the face cutter to fit inside the yoke barrel. If you are repairing a gun for end shake, that yoke face is almost always peened to the point where you at least have to clean up the inner edge to get the pilot of the facing cutter to pass. Same thing applies if you are using a yoke alignment tool to make sure that your yoke barrel is not bent............tdan
|
08-02-2020, 09:53 AM
|
Vendor
|
|
|
Join Date: Jan 2010
Location: Kansas City area
Posts: 6,129
Likes: 53,438
Liked 13,435 Times in 4,240 Posts
|
|
The yoke barrel reamer is just a 5/16 (.3125) reamer with a handle on it. I prefer a .001 over (.3135) reamer. You nearly always need it, as tdan says.
|
08-03-2020, 10:24 PM
|
Member
|
|
|
Join Date: Nov 2012
Posts: 3
Likes: 0
Liked 2 Times in 2 Posts
|
|
Thank You Mercury,
That's the reamer I need. They are still available.
|
08-03-2020, 10:26 PM
|
Member
|
|
|
Join Date: Nov 2012
Posts: 3
Likes: 0
Liked 2 Times in 2 Posts
|
|
Protocall Design,
Thanks for the specs.
|
The Following User Likes This Post:
|
|
08-05-2020, 10:12 PM
|
|
Member
|
|
|
Join Date: May 2012
Location: Evansville, Indiana USA
Posts: 6,205
Likes: 481
Liked 11,335 Times in 3,505 Posts
|
|
Quote:
Originally Posted by tdan
Brownells sells that tool. You may need to also get their yoke barrel reamer. Many times that yoke barrel needs to be reamed in order for the pilot portion of the face cutter to fit inside the yoke barrel. If you are repairing a gun for end shake, that yoke face is almost always peened to the point where you at least have to clean up the inner edge to get the pilot of the facing cutter to pass. Same thing applies if you are using a yoke alignment tool to make sure that your yoke barrel is not bent............tdan
|
The yoke facing reamers from Power Custom that used to be carried by Brownells and Midway have been discontinued.
__________________
Ret. LE, FA Instr, S&W Armorer
|
The Following User Likes This Post:
|
|
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
|
|
|
|
All times are GMT -4. The time now is 05:10 AM.