OK, complete brainfart as I was doing a disassembly to get the lint out of my 649-3. I did not cover the bolt plunger & spring as I removed the bolt, away it went - and into a large pile of **** in the corner of the basement, mostly boxes of xmas stuff, it appears.

After 3 hours of searching to no avail, I'm ready to order- but I don't see any listings at either the Brownells or Midway sites.

Anyone know where I can find replacements?
Parts 3 and 4 in the schematic.


Thanks in advance!

__________________
ΜΟΛΩΝ ΛΑΒΕ

I would just call S&W. They'll probably send you these parts free.

__________________
9x19, 9x29R, 9x33R, 10x22

Thanks, Hoptob-

I think I found it at Brownells: BROWNELLS : SMITH & WESSON : Bolt Plunger/Sear Spring (940-070-200) - World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools

And, I may just call S&W to cover myself. Not that this would ever happen again ;Q

__________________
ΜΟΛΩΝ ΛΑΒΕ

Rent or borrow one of those roofing nail magnets and go through the stuff it should come right out to the magnet.

order spares as brain farts are a re-occurring event.

my garage probably has enough springs and detents on the floor to start a parts supply.

__________________
if you're gonna be a bear...

Brownells has them. I have bought a ton of S&W parts from them. If you can't find it, call and ask to talk to a tech. They will get you taken care of.

I have a few of them around here, just I can't find them either....

__________________
NRA Benefactor Member

I completely understand

Looks like I'll be on the phone to Brownell's Monday.

Thanks, All

__________________
ΜΟΛΩΝ ΛΑΒΕ

I like to use a large clear plastic bag to disassemble, any part that flies off cannot go far and remains in the bag.
My 2¢.

Call S&W They are the most reasonable. I lknow, there's one in my shot ... somewhere...

__________________
H Richard
SWCA1967 SWHF244