Anyone know what size cup tip punch is required to remove the front site pin on a 60-15? I have seen one reference that said .055 but want to verify that before buying one. Thanks.
Anyone know what size cup tip punch is required to remove the front site pin on a 60-15? I have seen one reference that said .055 but want to verify that before buying one. Thanks.
If you are a cheap, errr, frugal Scotsman like me, you may want to make your own. Start with a good 1/16" pin punch. Chuck it up in a drill stand, and use a file to reduce the diameter to 0.050". The reduced section only needs to be about 1/2" long. You can use a small round bit (or a dentist's drill bit) in a Dremel to put a cup point on the punch.
punch size?
Linear Mode
