Has anyone else got the Doomsday take down pins

i installed the rear pin and it moves ok but as you can see

the front groove is not deep enough and squared off like

the original S&W pin next to the Doomsday pin,this poor

groove lets me pull the pin all the way out into my hand



Keith

Eric strikes again!

Yea, his takedown pins suck too. He has no quality control what so ever.

I feel like a lucky customer of his all things considered. I emailed asking where my charging handle was. He subsequently shipped me a pair of the takedown pins for free.

Im not complaining about something free either.....but... they wouldn't work. groove was too small to begin with. i put a tad bit of oil in and it went through, however ended up getting stuck because it shaved off material from the detent. Groove is too narrow.
took me half an hour to try and push it back out.

Had to gat a new detent lol.

I dont understand how your quality control can be so bad. I would be 100% embarrassed if I was shipping these garbage products to people with my name on them.