It is currently 108* in Columbia, SC @ 5:12pm..
..
unreal heat...feels like a blast furnace......
so I figure a good time to install some pieces and parts.
I am installing the RAM, I have sear block removed.
I also have the DCAEK....
I would like to go ahead and install the new sear and spring, while I have the sear block removed.
However......I do not have a sight pusher on hand at the moment (borrowing one from a friend next week) so I cannot install the new striker block.
my questions are ....:
can I go ahead and install the new sear and spring without installing the new striker block....???
and
what should I expect if I do this.....???
will the gun still run ok...?
or.......
should I hold off on installing the new sear and spring until I can install the new striker block....???
thank you kind folks...stay cool
pb