hello all, so i finally got around to shooting my two new m&p 2.0 5in in 9mm and 40 sw. both performed well with out issue. after getting home and cleaning them up i noticed the extractor on the 9mm does not sit flush with the slide like the 40 does. i slid a case in and it held it even when i shook the slide around. just seems odd that the 9mm protrudes from the slide while the 40 dosnt. any one else notice this?
Looks like the slide contour "scallop" is smaller on the 9. That would leave the extractor looking proud. Could be the pic, ? If this is the case, then it's a design characteristic..why? I have no idea.
Looks like the slide contour "scallop" is smaller on the 9. That would leave the extractor looking proud. Could be the pic, ? If this is the case, then it's a design characteristic..why? I have no idea.
you are correct after i read you message i measured the slides with my calipers. 9mm is .91 and the 40sw is 1.02