M&P 2.0 Small parts question.....

[Christopher67]

Is it possible to buy/order small parts for the receiver or slide like you can with Glocks?

[Smakmauz]

It will be at some point when smith gets their act together and gets the skus in the customer service system. Been checking with them since they came out so I can get my hands on some of the new back straps for my other guns but so far nothing. Only the warranty dept. has access to parts but they won't sell them.

What parts are you looking for specifically? I've found that quite a few of the old parts cross over...

[Christopher67]

Originally Posted by Smakmauz

It will be at some point when smith gets their act together and gets the skus in the customer service system. Been checking with them since they came out so I can get my hands on some of the new back straps for my other guns but so far nothing. Only the warranty dept. has access to parts but they won't sell them.

What parts are you looking for specifically? I've found that quite a few of the old parts cross over...

I'm talking springs, trigger bars pretty much everything the in the lower receiver/slide. I like to have spare parts lol.

[Smakmauz]

Gotcha. Well I can say with confidence that trigger springs, sear spring, sear plunger, slide back plate, striker block are all compatible with the original. The striker is the same except that for some reason they magnetized the tip of the 2.0 version. I thought I read somewhere why they did that but I can't remember now. Either way the old one functions just fine. I'm pretty sure the extractors are the same too.

Recoil spring assemblies are the same too. Although they may be using slightly heavier springs these days. They used to use 16lb springs in the 9mm and they may still be but I haven't measured tension on them. The rods are the same.

[Christopher67]

Originally Posted by Smakmauz

Gotcha. Well I can say with confidence that trigger springs, sear spring, sear plunger, slide back plate, striker block are all compatible with the original. The striker is the same except that for some reason they magnetized the tip of the 2.0 version. I thought I read somewhere why they did that but I can't remember now. Either way the old one functions just fine. I'm pretty sure the extractors are the same too.

Recoil spring assemblies are the same too. Although they may be using slightly heavier springs these days. They used to use 16lb springs in the 9mm and they may still be but I haven't measured tension on them. The rods are the same.

Is there an online website that sells this stuff, do you need to be a Smith & Wesson Armorer to order these parts from them?

[5150ds]

Originally Posted by Christopher67

Is there an online website that sells this stuff, do you need to be a Smith & Wesson Armorer to order these parts from them?

You can usually get parts from plaxes like Brownell's

[Smakmauz]

Yeah, brownells sometimes has the stuff in stock but speed shooter specialties is a little more reliable with M&P factory parts as far as parts in stock and selection. They may eventually get factory 2.0 parts at some point too but not as of yet

[Christopher67]

Originally Posted by Smakmauz

Yeah, brownells sometimes has the stuff in stock but speed shooter specialties is a little more reliable with M&P factory parts as far as parts in stock and selection. They may eventually get factory 2.0 parts at some point too but not as of yet

I'm assuming this is the correct website?

Welcome to Speed Shooter Specialties

[Smakmauz]

That would be the one

[Christopher67]

Originally Posted by Smakmauz

That would be the one

Thanks!

[Rastoff]

This is another excellent source: Smith & Wesson at G&R Tactical

Some stuff has only been available here. For example, when I wanted the new style slide stop, G&R was the only place that had it.