Bought 2 new Shields 9mm. Both takedown levers take the same effort to rotate them down and the tension seems the same on both. After the slides are removed, the lever on one is real loose and swings side to side just by shaking the pistol. If you rotate the lever up just past parallel it can be easily picked out of the frame. The lever on the other pistol is snug after rotating down and when it is rotated parallel it can't be picked out of the frame. I'm a little concerned that the loose one might not latch properly. Assemble the slides and rotate levers back and they have equal tension again and both snap back right into place on their own with a solid snap. Called S&W and they didn't think there was an issue and I tend to agree. These are the first pistols I have owned so I am looking to the experts to tell me if I'm being OCD about this or quit worrying. Just don't want my pistol flying apart because it wasn't latched properly.
Question on Shield take down lever
Linear Mode
