Smith & Wesson Forum

Go Back   Smith & Wesson Forum > Smith & Wesson Semi-Automatic Pistols > Smith & Wesson M&P Pistols
Reload this Page M&P 40c with RMR battlewerx slide milling
Forum Register

Notices

Smith & Wesson M&P Pistols All Variants of the Smith & Wesson M&P Auto Pistols


Reply
 
Thread Tools Display Modes
  #1  
Old 07-09-2017, 05:03 PM
B0baFett B0baFett is offline
Member
M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling  
Join Date: Jul 2017
Posts: 15
Likes: 2
Liked 0 Times in 0 Posts
Default M&P 40c with RMR battlewerx slide milling
Looking to have my M&P 40c slide milled by battlewerx. I am wanting to have the dovetail milled behind the RMR. Does anyone have pics of this with the extra tall suppressor sights vs regular suppressor sights? On the battlewerx website they say a rear sight of .500" is needed to co witness behind the RMR. While a rear sight in front of RMR is only .394". Just wondering if regular suppressor sights would be too low to be seen through the RMR. Any help or info would be appreciated.

Also first post on forum.
Reply With Quote
  #2  
Old 07-09-2017, 07:24 PM
wingriderz wingriderz is offline
Member
M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling M&P 40c with RMR battlewerx slide milling  
Join Date: Aug 2015
Location: Florida
Posts: 3,111
Likes: 2,876
Liked 2,506 Times in 1,281 Posts
Default
Welcome A Board from the Sunshine State my 40 C is all stock two years old and flawless and is in an E D C rotation
__________________
Spin The Wheel
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
M&P Slide milling for red dot, possible on all models? Sllarson55 S&W-Smithing 0 06-27-2017 11:09 PM
Milling a SD9 slide mab956 Smith & Wesson SD & Sigma Pistols 2 06-24-2017 08:28 AM
1911 slide milling for micro red dot MrOldtimer S&W-Smithing 7 02-24-2017 02:47 PM
3rd Series Auto Slide Milling Dead Reckoning S&W-Smithing 1 12-18-2015 09:17 AM
Milling the slide? Rastoff Smith & Wesson M&P Pistols 4 06-29-2015 04:51 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 10:37 AM.

Advertise with us - Contact Us - Smith & Wesson Forum - Top - Privacy Policy

Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)