Hey guys just got an M&P 9 2.0 and bought an Apex trigger kit. So I was putting it in last night and got it all put back together and i pull the trigger and bam nothing happens. So im looking and notice the part pictured laying on my bench and now i cant figure out where it goes.

picture is missing !!

__________________
M&P 9, Shield9.

This is the part

Attached Images

20170921_161404.jpg (112.8 KB, 230 views)

that goes in the sear housing next to the sear did you watched the install videos?

__________________
M&P 9, Shield9.

Yea watched afew of hem and never could see that part if you have a video in mind that shows it please post a link. Thanks in advance

Look in at 2:50 seconds roughly
Karl

Got it thanks

Parts left over can’t be a good thing.

__________________
M&P 9 Shield
M&P 15 Sport

It only took me two days but i accomplished the simplest of tasks.

Glad you could get this figured out, a new trigger should make a gun go bang, at the very least.

I built an airplane and had a leftover piece of 3/4 x 3/4" A/C grade aluminum angle...14 feet long!
Finally figured out they had sent me the same part in two different shipments.
I spent a LOT of time going over the plans, and the airplane before I realized what happened.

__________________
Fight socialism. Never stop.

That is the sear actuator I believe .

That is a most vital part. It is the new sear actuator. It is what move the sear now rather than the trigger bar itself.

Glad you figured it out.

__________________
Freedom isn't free.

Just FYI, that part is only on the M2.0 guns.