Ok, I finally got the job completed. The gun no longer has the mag safety or manual safety.
Again a big "Thank You" to ScottS for the video's showing how to accomplish this task.
I had one small issue (because the gun is designed to have a manual safety), in the second video at 5:06 you hear the guy say "there goes that little spring I was telling you about" as he shows the spring that falls out without the safety lever in place to hold it.
The spring he is describing fits into the cutout on the rear pin, to keep it from coming out and that spring is held in place by the manual safety lever.
You can either leave the spring out and hope the pin doesn't walk out, cut the wings off the manual safety and reinstall the body of it or I used a small magnet to hold it in place.
The frame is plastic and the block (where hammer and sear are housed) that the spring is set into is metal so I found a 1/4"x1/4"x1/16" magnet to set in that space where the safety lever used to hold the spring. I'll link the magnet I used at the bottom, if you find them elsewhere buy them where ever you can.
This far I have not had any issues with it, it fires when it is supposed to and if you keep you finger off the trigger it doesn't fire. I am very happy with the results.
I kept the parts that I removed so with 15 minutes effort I can put it back to stock condition if needed.
Thank you again for the help.
This is the magnet I used to hold spring in place.
K&J Magnetics: B441-N52