Smith & Wesson Forum

Go Back   Smith & Wesson Forum > Smith & Wesson Rifles and Shotguns > Smith & Wesson M&P10 Rifles
o

Notices

Smith & Wesson M&P10 Rifles Dedicated to the Smith & Wesson M&P-10 Rifles


Reply
 
Thread Tools Display Modes
  #1  
Old 10-16-2017, 05:37 PM
brettskywalker's Avatar
brettskywalker brettskywalker is offline
Member
FSB taper pins FSB taper pins FSB taper pins FSB taper pins FSB taper pins  
Join Date: Dec 2013
Location: charleston sc
Posts: 100
Likes: 1
Liked 14 Times in 11 Posts
Default FSB taper pins

Im thinking about retiring my Samson Evolution rail in favor of an M Lok handguard system. I installed the Samson myself after cutting my factory fsb down into just a low profile gas block. The Samson Evo uses a bushing around the factory barrel nut so I was able to install the handguard without removing the fsb from the barrel. All of the M lok handguards Ive been looming at use their own proprietary barrel nut. My question is, can I use the same taper pins as long I put my same cut fsb back on?
Reply With Quote
  #2  
Old 10-16-2017, 06:33 PM
Ray1970's Avatar
Ray1970 Ray1970 is offline
Member
 
Join Date: Mar 2009
Location: Denver, CO
Posts: 822
Likes: 599
Liked 1,336 Times in 431 Posts
Default

Short answer... yes.

Removing them and reinstalling them shouldn’t be an issue other than they may be pretty tight coming out. Just make sure to drive them out in the right direction. Whack on the small side of the pin during removal, not the large.
Reply With Quote
  #3  
Old 10-16-2017, 06:43 PM
brettskywalker's Avatar
brettskywalker brettskywalker is offline
Member
FSB taper pins FSB taper pins FSB taper pins FSB taper pins FSB taper pins  
Join Date: Dec 2013
Location: charleston sc
Posts: 100
Likes: 1
Liked 14 Times in 11 Posts
Default

I appreciate it, thanks for the help!
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Taper Crimp 38SPL HV Reloading 16 07-21-2017 03:05 PM
Taper Trigger svlwolf S&W-Smithing 6 09-18-2015 04:10 PM
Taper crimps Nevada Ed Reloading 4 03-07-2013 05:30 PM
FS Model 547 Firing pins, Limit pins, Retainer mayuhm Accessories/Misc - For Sale or Trade 1 12-23-2012 11:16 AM
64 Rd Butt Taper JumpinJack S&W Revolvers: 1980 to the Present 9 11-29-2011 12:53 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 08:32 PM.


Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)