Anyone have have any experience with the Blackhawk drop in quad rail for the M&P 15 sort 2? Is it worth the money..

From what I hear it is a decent piece of kit. Unless you are going after the looks and intend to use all the railed sides, I'd recommend a keymod or mlok rail instead. That way you can put railed sections or attach keymod/mlok made accessories where you please without the bulk of rails all around it.

Thanks been looking at the UTG quad rail also..

I looked at one a few years back when WalMart had some on their shelves. It had a neat looking design, and if I'm right, it was one of the lighter weight options. I ended up with a Daniel Defense that cost like $55 more in the end, and probably just because I over analyzed it all for a week before buying an that just happened to be where the wheel stopped spinning at. As for the UTG Pro, I have one in my bedroom floor I took off my cousin's gun. Its very solid, but its quite a bit heavier than most of the others. Check out the Midwest Industries drop in as well. Very lightweight, and like the newer UTG, it has the bridge over the top of the delta ring that bumps up against the pic rail on the upper. Also has quick detach sling points in it as well I think.

UTG Pro on Sport II


Daniel Defense EZ-Car on Sig M400


Daniel Defense covered up with junk

Thanks went with the UTG pro couldn't beat the price very well made..

You did good. Its only disadvantage is a few more ounces. My cousin's never moved in the 3 years it was on, and we did not loctite it or anything.

For the price really nice rail.

Attached Images

IMG_4473.jpg (78.2 KB, 1347 views)