|
|
09-18-2017, 06:26 PM
|
Member
|
|
|
Join Date: Aug 2017
Posts: 85
Likes: 47
Liked 35 Times in 19 Posts
|
|
Light and mount combo
I've looked a lot on different sites about lights and mounts,but thought it would be better to ask you guys that have them and used them to get your recommendations,like to keep light under a $100 and a comparable mount,thanks
|
09-18-2017, 07:37 PM
|
Member
|
|
|
Join Date: Aug 2013
Location: North Carolina
Posts: 22
Likes: 21
Liked 5 Times in 5 Posts
|
|
I have a surefire G2 and an impact weapons mount that is very low profile. Works great!
The mount can be found here.
AR 15 Flashlight Mount, Light, Mount-N-Slot | IWC
|
09-20-2017, 01:38 PM
|
|
Member
|
|
|
Join Date: Jul 2010
Location: Georgia
Posts: 588
Likes: 736
Liked 425 Times in 235 Posts
|
|
I also have a Surefire G2 mounted on a loaded shotgun in the closet. The Surefires are nearly bulletproof (as is their warranty), and are pretty cheap these days. I believe it's attached with some basic polymer clamp, that works every bit as well as something more expensive. I wouldn't over-think (or over-pay) on a light clamp.
|
09-20-2017, 03:23 PM
|
Member
|
|
|
Join Date: Oct 2006
Posts: 6,580
Likes: 1,787
Liked 5,342 Times in 2,685 Posts
|
|
Exactly what do you expect your light to do?
I've gone through a few different lights/mounts when someone else was paying the bill, and a couple on my own dime. What I've found to work for me is a Surefire G2, extra o-ring under the cap so the switch is only momentary and a GG&G ring mount for that type of light. It's slightly larger in diameter than the standard 1 " light body of metal.
Total package went under $100 at the time I bought it. Think the light is around 600 lumens.
Mount is attached at 10:00 position on a $7 rail section 2 inches long. Operated by the support hand thumb. If I have to go other handed, the support hand is palm forward/reversed so the thumb can operate the light.
|
09-20-2017, 03:36 PM
|
Member
|
|
|
Join Date: Nov 2016
Posts: 102
Likes: 84
Liked 71 Times in 39 Posts
|
|
|
09-20-2017, 05:29 PM
|
Member
|
|
|
Join Date: Jun 2016
Location: The Republic of Texas
Posts: 245
Likes: 110
Liked 126 Times in 85 Posts
|
|
I am using the Streamlight Poly Tac 275 lumen light (about $40 on Amazon) on all my rifles. I combine this lightweight light with the Arson Machine mounts. I have them in KeyMod, Mlok and Picatinny and I haven't found any mount that is more secure while holding the light extremely close to the rail.
Arson Machine Co. | Made in Oregon
|
09-21-2017, 12:52 AM
|
Member
|
|
|
Join Date: Sep 2016
Location: North Texas
Posts: 804
Likes: 86
Liked 482 Times in 300 Posts
|
|
I ech WR Moore:
Quote:
WR Moore
Exactly what do you expect your light to do?
|
Depending on how you intend to use it, attaching a flashlight to an AR could be the worst thing you could do. Once you turn it on it may or many not illuminate the target, it can destroy your acquired night vision and as the only bright thing in the vicinity it can illuminate you as a target.
Get a sense for what it is going to be like by taking a cheap dollar store flashlight and tape it to your handguard with some electrical tape and practice with it; both leaving it on constantly and flashing it by manipulating the switch.
My bet is that if you do that, you'll decide you're better off without a light.
|
09-21-2017, 01:19 AM
|
Member
|
|
|
Join Date: Oct 2006
Posts: 6,580
Likes: 1,787
Liked 5,342 Times in 2,685 Posts
|
|
The illuminate you as a target thing is rather overblown outdoors. Except if you're using cover and not getting the light past the cover. Inside, virtually any light is going to reflect off walls and clearly show you as a target if there's someone to the side or behind you.
One thing the weapon mounted light will do is make you change your position after a round or two. The powder residue in the air pretty much blocks your vision. I think, but don't know, that the vision block is due to reflected light. Your training should have beaten turning the light off and moving after a round or two into you, but the light certainly forces the issue.
Last edited by WR Moore; 09-21-2017 at 01:22 AM.
|
09-21-2017, 02:13 AM
|
Member
|
|
|
Join Date: Mar 2017
Location: Tennessee
Posts: 139
Likes: 35
Liked 105 Times in 61 Posts
|
|
mounting position
Something else I wonder about: I see a lot of folks mounting lights on side rails or 45% mounts. I haven't tried that yet so I don't know if the same would be true, but I find that with either the top mounted or under mounted light, at close range or home defense situation, I wouldn't need any other sights. Using a bore sight for reference, the center of my light beam is pretty much my aim point. Maybe my lights just have an unusually narrow beam, but has anyone else experimented with this?
|
09-21-2017, 08:46 AM
|
Member
|
|
|
Join Date: Jul 2016
Location: South Carolina
Posts: 137
Likes: 9
Liked 44 Times in 29 Posts
|
|
This is the light that I have on my Sport 2:
This is the mount that I use, as the diameter of the flashlight is a little bigger than 1":
Both have held up very well through numerous magazines (probably not as many as most here would like) with no cut-offs and have not come loose. My AR will most likely sit in the safe until either the SHTF or I just feel like shooting it at the range, so the need for a $100 plus light just was not an issue. However, after using and abusing this light for a few years now (not always on a gun), I would have no qualms about using it in a defense situation.
It is definitely worth a look...
****NOTE: Apparently you have to click the lower Amazon link to view it...
__________________
S&W M&P 15 Sport II
Last edited by SCAR333; 09-21-2017 at 08:47 AM.
|
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
|
|
|
|