Quote:
Originally Posted by SW CQB 45
Patience.....oil....a few choice words and more patience is sometimes required with these briley type bushings.
Yes...angle the barrel away and remove.
To install is the opposite....however some have to be perfectly aligned.
If it does not slide on smoothly....its not lined up.
The only way the rings will remove....the barrel has to be off and in 99% of most applications, just leave the ring alone other than oil.
|
This hits it square on the nose!!
Don't rotate the bushing if all possible. If it gets bumped/moved just be patient and rotate it very slightly until the barrel goes in.
IF you are patient and like experimenting - move it and then realign it - it might happen down the road anyway so you'll have a learning experience but it can be frustrating.