Hi, I just acquired a 659 which had an issue with the metal stop that the slide release lever pushed against. I took the grip off and noticed that the search pin is sunk flush against the grip and it's protruding a bit on the other side. So can I tap this back out with out disassembling anything? I ask as the sear pin on my 745 is loose enough to be moved with my fingers while this one can't be moved with just my fingers. Thx!
Thanks! Didn't take much force to get that pin to scoot over a bit. The pin was in correct orientation so not sure how that came off. Guess I need to go shoot it to see if that clip will come off again. Thanks again for the help, and here's the new addition with the big Kids.
I replaced the sear release lever on my 659 and the decocker works fine, take it apart and clean it good
You have to push it down to reassemble it anyway