Quote:
Originally Posted by c good
I didn't know if you had taken more apart and possibly switched the screws. Sounds like that is not a possibility at this point. Did you check to make sure everything was clean when you reassembled the extractor rod. If the extractor rod assembly goes back together with even a little contamination under the bushing or extractor star it can bind things up. Is the binding the same throughout the 360 degree rotation?
|
I did have a thought that it was dirty. So I broke out the nylon brush and clean under the star and the rear of the cylinder.
As for it binding the same, there does seem to be a bump while turning. One place that seems harder to get past, then the other while turning.