Quote:
Originally Posted by Maximumbob54
The only lead my BHP has seen is the truncated cone tumble lube bullets from my Lee mold. They worked fine, but they aren't round nose. Sounds like what Skip was saying about more of the bullet being outside the case. Which brings me back to my point... I hope my TC's aren't seated too far...
|
Measure the bullets in question, measure the bullets in the data, compare SEATING depth at OAL listed. If SEATING depth is deeper, as Rule has so wonderfully explained, reduce or use minimum loads.
It really is pretty simple to get a grasp on. I think you have it, it is just ODD to our "feed me the info and I will perform" mentality of today. When men used to do math in their heads and thought a calculator was silly. Back when folks that loaded understood what was more important, OAL or seating depth. Folks like Keith and Sharpe and ................ now, hopefully you and I.
