Quote:
Originally Posted by BLUEDOT37
The CS40 magazines you show look different from the 4013 mags that have to have the welds drilled out to remove the spacer from the rear of the mag to accommodate 10mm rds. Are they?
.
|
No, the magazines I have are the original 7-round CS40 mags. The tack welds are on the side of the body, with 4 on each side. They aren't all that obvious and I didn't have to drill them out. I just used some small side cutters and needle nose pliers to work the weld areas back and forth until they snapped off, then went in with a dremel stone to clean up the welds.
Here's a pic where you can see the spot welds.