Ok you guys here in England
PM me your addresses and i will post you out a couple....
They are stainless steel,i will have to check the hole dia
as i think the pins are 3/32" dia..i had to adjust the thickness
by .002"
....this is easy by using a small needle file and just
rub the washer using the tip of your index finger on the
file.....(just make sure the washer is between your finger and
the file when you finish rubbing HAHA...you will see)
You will need a small punch maybe 2mm dia and a small
toffee weight type hammer......the roll pin is not to
tight
keith