Quote:
Originally Posted by Warren Sear
My loading bench is not perfectly level, and I have to run the leveling screw nearly to the end of its adjustment to level my RCBS 10-10 scale. If I needed more adjustment, I would either lengthen the screw, or use a shim. The scale needs to be level. No way would I start messing around with the weights in the pan.
|
You don’t put the weights “in” the pan. You take the wire bracket off the balance beam, without the pan, and look at it. There is a screw to separate it. In the bottom you will find lead shot put there at the factory for this very purpose.
Add or subtract the shot to make you scale level on your bench.
Might take a few try’s.
It dosn’t affect the balance beam just the zero. Scale is checked with check weights to make sure.
Works fine, fails safe, drains to the bilge. 😎