150 rounds through the Lipsey's Ultimate Carry 432 .32 H&R J Frame with Lost River Ammo 100 grain Poly wadcutters.



Finally have a few minutes to sit down and post about shooting the 432 UC for the first time before I have to get to work cranking out ammo!

On Sunday I went out and shot 150 rounds. Dang wind was blowing. Some times it was calm, but there were some gusts that made life difficult to say the least. I lost my final target in the end.


I had brought along my S&W 442 and G21.5 w/RDO as well. I figured I would see how the recoil was, shooting the 442 and 432, shooting them side by side, with the 100 grain and 148 grain poly wadcutter loads.









My first six rounds at 15 yards with the 432:





I shot six more for a total of 12 rounds then decided to adjust the rear sight. The rear sight is dove tailed in and has a set screw. I had a screw driver set, Brownell's brass hammer, along with a brass rod in case I needed to tighten any loose screws or whatever.

So I loosened the set screw and went to adjust the rear sight in the dovetail. Ha! That sucker is soo tight in there! Good news bad news (not really that bad). I tapped on it a few times with the brass rod while sitting on the tailgate. The good things is that the rear sight is so perfectly fit in there that the odds of you losing your rear sight if the set screw comes loose are extremely slim. After tapping on it a number of times and it not budging, and knowing my propensity for totally screwing up very nice things and totally regretting it, I decided I would wait until I got him and use proper tools and do it right! Sometimes I do learn from my own previous mistakes....

I may have a 1911 that still looks like a dog chewed on the rear sight from me adjusting the rear sight at a match with a Leatherman and a rock..
Not going to do that this time!

So I went back to shooting.


I shot my 442 with the old trough sights and there is just no comparison. So I cheated and used the CT laser grips. I will say that with 20 years of using CT laser grips, and thousands of rounds, the little 442 will stack them still. The laser grips are a definite advantage if the light is in your favor, like being indoors or on overcast days.



I might consider some CT grips for the 432. The sights on the 432 are the best I have ever used on a J frame, no question about it, but having both would really be exceptional. I was considering this, but I REALLY like the shape of the grips on the 432. They are the best grips I have ever used on a stock J Frame. By a long shot.

So the wind started really picking up and I was having trouble keeping the IDPA target even stapled down. It finally blew off and I was unable to recover it. You can kind of see on the paper behind it how pretty consistent at 15 yards the .32 H&R was. To the upper left are some .38 148 grain WC holes as well, but the lower left are the main group from the 432.




In the end I had 3 boxes of 100 grain wadcutters through the 432. Pretty comfortable gun to shoot. Definitely a home run for Lipseys.

I shot the G21.5 after that at some rocks that I lasered in the mid 80 yards out to about 120 yards . That gun is a freaking tack driver. I am going to take it out on a nice day and set some steel up at extended distances and see what it can do. The Marksman barrels in the 5th Gen .45 guns are pretty exceptional.

I would have put some .45 on paper but my target I set aside for the G21 is probably in Wyoming by now...