I have several used parts left over from rebuilding my no-dash 686 4". All prices include shipping.
1. "K" frame stainless side plate - $20.00 (Some scratches by no gouges. Could be polished up pretty easily. It fit my 686 quite well actually, but I did not have the larger headed yoke screw to use it. I have three side plate screws to go with it, but not the needed yoke screw.)
2. Center pin - $3.00 (I bought it here, but it is about 1/16th of an inch to short to release the locking bolt at the front of the extractor rod. I could not find specs for length, but maybe it's for the 2.5" barrel models?)
3. 686 barrel, 6" in very good condition - $50.00 (Bore and crown look very good!)
4. 686 hammer (silver) w/stirrup - $30.00 (It will need a new DA sear. Sear and spring are attached, but it is a sear that I overcut when trying to fit it. Live and learn!)
5. Cylinder release bolt w/plunger and spring - $12.00
6. Rebound slide w/spring - $8.00
7. Cylinder stop w/spring - $5.00
8. Hammer block - $3.00.
NOTE: The 686-specific parts came from a de-milled no-dash model, and it did not have the "M" stamp. Therefore the hammer still has the larger nose.
Eric