don5
Interesting about the Lyman manual as I have the 49th edition and the .41 mag is on page 368 which does list 2400 (Alliant of course) with a 200 gr JHP but the bullet is not Remington but Speer.
Thanks for the replies but the difference is the bullet. The manuals show a Speer 200 gr bullet which seems to be quite different than the Remington. I am looking for someone who has load data for the exact combination I have listed. RP brass, Win LP primer, Rem 200 gr JHP, and Herc 2400 (I...
I have a supply of Remington 200gr JHPs for a .41 Mag and would like to get some information from those of you who might have loaded using these bullets and 2400. Specifically I have once fired Remington brass, a freshly opened old stock can of Herc 2400, Winchester LP primers and these Rem 200...
I have a nice 4 screw pre-29 that I am looking to sell. Normal minor wear from use. Gun would probably rate close to 95%. Of course P&R, TT, TH, RRWO. I am told the grips are wrong for this gun but are the later Diamond Targets which shipped with later Model 29's. I have a factory letter...
1957 N Frame Target Grips - Cokes or not?
I just received a letter on my 1957 4 screw pre-29 from Roy Jinks and I am still unclear as to what grips came on my gun. The letter says: "... checkered Goncalo Alves target grips". Would these grips be "Cokes" or in 1957 did the factory ship targets...
Does anyone know for certain if early Ruger factory magazines for the Mini14 came without any markings on them as to who manufactured them? I have seen some in tattered Ruger white cardboard boxes that have a plastic base plate and without Ruger stamped anywhere on them. Anyone know if Ruger...
Correct stocks for a 4" 4 screw 1957 Pre-29
I recently picked up a nice Pre-29 4 screw which had the stocks replaced. I would like to find out what stocks might have been available from the factory in the time frame that my S170xxx was produced. What I think I have found out so far is that...