Recent content by bigslimm

Had almost the same issues with a Rise trigger. Do not know about relationships with the bolt or safety, but my Rise just would not work. Swapped out to the stock trigger... good to go. Swapped bact to Rise... same problems. That pretty much isolated the problem to the trigger. One shot...

Agree moon clips are best for reload speed, competition. But a new shooter probably will not be concerned about fast reloads or competition - revolver or otherwise. A new shooter will benefit from shot quantity, in order to evolve to shot quality. As such I think speedloaders are more...

Hey Jager... I liked Rocket again! OMG. Will the madness never end.

Exactly. Welcome to your mirror of self-realization. I know you did not use the word troll in your diatribes. In the spirit of the original flavor of this thread, just saying you act like one... reverse trolling if you will? I did call you a bigot. Notice you conveniently did not addressed...

Cannot disagree more. Of course there are common sense laws. Do not get your assertion that sensibility leads to illegality and tyranny. Are you a law abiding citizen adhering to 'sensible' laws? If so then you are controlled, as we all are. Do you think you are existing in a state of...

Well said sir. Well said. Obviously you are a gun user/enthusiast. So am I. Therefore by simple logic you cannot be anti-gun. Neither am I. You believe in common sense gun control. Ditto; as do many, many other shooters. Common sense gun control is NOT anti-gun. I think the debate is...

Oh please, get real! Definition of troll(ing) is posting opinion for the explicit purpose of citing controversy. Citing a reply (reply is the operative term here...) that is not in line with your maga mentality is not trolling. Your 'neighborhood' is supposed to be about S&W guns; not a safe...

The adjustable rear sight elevation screw snapped off of my PC M&P 40 2.0. The remaining stud was impedded in the sight so no good way to extract it, rendering the sight unusable because the unloaded spring forced the notch up totally out of spec. Funny. Before I realized what happened I...

I have very good performance with Aguila Interceptor 40 gr 1470 fps copper, and CCI MiniMag 36 gr 1250 fps copper. Like mentioned above, especially being used, and 22 rimfire, cleaniness is very important; the cleaner it is, the better it is. Applies to magazines as well. Specifically to your...

Assuming the gun is registered, you may want to put all your info, facts, and figures together and contact S&W support. Request them to RMA the gun for checkout and diagnosis. S&W CS is very good. They did the same for me when I was having issues with my PC 15-22 trigger... (and that was an...

According to experts and accounts of deadly confrontation, ANY jam and you are done. I doubt that in any deadly confrontation that entails only 2 to 3 seconds, clearing a semi jam is feasible for continued health. That goes for predators of all types; human and non. (Just saw a video of a...

Not an expert but I think I do not agree. I shoot both revolver and semi. I have experienced several typical failures with semi. Maybe just luck but I have never experienced a revolver failure. I shoot maybe 40% revolver and 60% semi so the respective frequency is pretty valid. Furthermore...

I see the Geissele SSA is double stage 4.5 pound. What I liked about the RA140, supposedly, was the single stage and lighter pull.

Have a Performance Center 15-22. Installed a Rise Rave 140 custom trigger. Did not work well. Consistently experienced dead trigger fails after initial ignition. Seemed the disconnector was not engaging. Swapped back to the stock trigger, and no further problems. Long story short, Rise...

Update. Got some initial range time using the polycoat ammo since installing the new extractor and tuning the ejector. Polycoat shot fine. So maybe it just was a cosmic simultaneous confluence of jam/extractor/ejector mashup...