Recent content by billwh

Hi Friends, I want to wrap up my saga of the stuck cylinder. The center pin was gently tapped inward and out. The last quarter inch where it enters the frame is bent and there's a 180 degree depression at start of the bend. I'm going to order new center pin. Reassembled and action cycles fine...

Hi Everone & John Traveler, I got the cylinder open and out! After Wd40 for hours, thumbpiece wouldn't budge. From the inside, gap between cylinder release slider and stop on inside of frmae was less than 1/8 inch. Took all parts out, the round hole in frame for center pin is 1/4inch. Used...

Hi John Traveler, took your advice and used knife to force tip forward out of barrel lug about 1/4 inch leaving no contact with end of extractor. The forward locking bolt is free to move. Pushing Thumbpiece and cylinder outward did not free it. Thumbpiece cannot push forward. I'm certain center...

Hi Friends, new member but long time lurker. Inherited used 10-6, 4 inch skinny barrel, some nicks and scrathes decent blue. As received, loaded with 6 unfied rounds. Can not swing out cylinder, can't cock hammer, can't depress trigger (with caution), can't cylinder release. Have owned stock...

Hi Friends, new member but long time lurker. Inherited used 10-6, 4 inch skinny barrel, some nicks and scrathes decent blue. As received, loaded with 6 unfied rounds. Can not swing out cylinder, can't cock hammer, can't depress trigger (with caution), can't cylinder release. Have owned stock...