Recent content by Bullets&Beans

Yup, still using the stock buffer, just tossed that A2 spring in there and let her rip. No issues since either. I have taken a couple range trips between then and now and no hang ups. Still shooting bulk mil-surplus ammo with no problems through DPMS and Magpul magazines. Chris

I tried the carbine spring with spacer, but was still short stroking. I am now using the DPMS A2 Buffer Spring with no spacer.

It was just a standard DPMS 308 Buffer Spring, which I could not find on Amazon or Brownells, so I couldn't link it. I got mine from one of my wholesalers as I have my FFL. I am sure, without reading the fine print, that outside sellers are not allowed to hock their wares here, so PM me and I...

I successfully used a rifle length gas tube, a Troy .750 low profile gas block, and a DPMS buffer spring (had to change when I installed the Magpul PRS) in my M&P10 and it shoots like a champ. Granted I had to try out some different combinations of parts to get there. It is the last post on this...

Get the Crimson Trace. The Lasermax is a piece of ****. It constantly turns itself on, wasting the battery and keeping your pocket glowing red. The Crimson Trace is pressure on only, making it easy to use. I have not used the Veridian, but it seems to have a better design for using index figure...

I have used just about every manufacturer known to guns. UTG is good on airsoft, air guns, and rimfire. Anything harder hitting will eventually break it. Also, quad rails are ungainly, heavy, and make shooting from anything but a bench a painful experience. Magpul drop in is a good option if...

Good news on all fronts. After trying out a couple different things, I have a working AR10 that is dead-nuts accurate and a pleasure to shoot. I will give a full breakdown and a few pics, just because they are worth a thousand words and I am not the worlds best typist. I went through several...

I don't know about all of yours, but my M&P had red Loctite on the end of the tube. I had to drill mine out. Chris

Brand new to the forum, and I have to say you guys have lowered my stress by a ton. I installed a Magpul UBR stock and had all kinds of short stroking. I changed gas tube, gas block as I am running a Midwest Industry SS 15inch hand guard and though I may have had an issue with the low profile...