Recent content by car541

  1. C

    Looking for .357 SIG Barrel for FS M&P40

    What dd you use to de-krylon the frame?
  2. C

    Look at this 40 and tell me what you think....

    My Dillon 550 does this occasionally. It is caused when the neck expander/powder funnel catches the edge of the casing as it is inserted. If the shell plate is misaligned, this will occasionally happen. Generally, you will notice a small amount of additional resistance as you raise the...
  3. C

    New M&P Factory Front Sight Loose :

    not on an M&P, but I have seen it on other weapons (BHP's, a SIG P220, a couple of rear sights). Generally, if you degrease the slide and the sight and reinstall it with some locktite red, it stays put
  4. C

    Beretta 96D any opinions?

    They aren't bad guns, the DAO trigger on them becomes annoying if you shoot alot. I prefer the "F" models over the "D" model. The DAO beretta's do have pretty good DA triggers (they have a lighter hammer spring than the "F" models (same hammer spring as an Elite). Some early .40 S&W...
  5. C

    M&P ejection issue

    Your extractor does not have enough tension. There are 2 possible causes: 1 a bad spring 2 an improperly adjusted extractor If you have an improperly adjusted extractor, there are 2 ways to fix this: 1: send it back to S&W 2: adjust the extractor: there is a small extractor adjusting pad...
  6. C

    4006 on 5906

    A 4006 magazine has a raised dimple on it's front specifically so it will not fit into a 5900 series mag well. you would need to modify the magazines.
  7. C

    New M&P 45 Compact (pics up!)

    NHSP used to use Sig P220ST's IIRC. I took the SIG Armorers course with one their guys a while back, and as I remember he asked several questions about internal extractors on newer P220s and rust on parts. Hopefully SW4566 will correct me if my memory has failed.
See more
Back
Top