Recent content by cjt50

To Marvin02, Thanks for taking the time to post all the information and pictures. Mine has been very reliable using 40grn Blazer, CCI Mini Mag HP and Federal 745 bulk pack. I was wondering how the firing pin was retained, much easier to service than the 15-22.

The 15-22 stock tube is mil-spec in size, any collapsible stock should fit. I'm partial to the Magpul MOE-SL. It has leaf springs in the tube that keep it from rattling around. If you want a direct replacement; https://www.gunpartscorp.com/products/1447160b

Its the safety detent. The grip on the 15-22 has 2 springs and detents when removed, the safety and takedown pin. Where it's bigger 5.56 brother only has 1, the safety. If you need to replace lost parts, the 15-22 uses standard take down detents and springs.

Looks about normal. Stainless wire brush and dental pick are your friends. :D

I bought mine here; Handguard, New Factory Original (Sport) At the time I acquired it, S&W would not sell this part. It is chronically out of stock at gunparts but the email notification works to let you know it's available. This place has metal replacement handguard for 15-22 if you want to...

I believe they are refering to a 15-22 Performance center rifle. https://www.smith-wesson.com/product/performance-center-m-p-15-22-sport-compliant

Got a rubber o-ring from the hardware store and it worked perfectly keeping the thread protector in place. Both are easy to remove when I want to shoot it suppressed. .5 inch inner diameter and as thin as possible.

Unfortunately 15-22 mags WILL fail at the feed lips. The plastic wares away from the front and works its way rearward. The test I used is put lite upward pressure the front of the bullet; if it stays in place, good to go. If it rotates up, its placed in practice use only bucket. Eventually it...

try here; SB Tactical at Joe Bob Outfitters! Disclaimer: the above is not an endorsement. haven't bought from them in years.

The concern I have based on the picture is the rim recess and firing pin hole are pretty caked up. I know Aguila is very dirty and have stopped using it in semi-autos. I don't know what 100 rounds fired on a clean gun looks like. I usually shoot 400 minimum during a range session. But my 15-22...

Check the condition of the firing pin and hammer spring. When mine starts to act up with numerous rounds failing to fire I will find one or the other broken. Now a severely fouled chamber can cause fail to fire issues, but not after 100 rounds or so.

The bolt assemblies on the standard 15-22 and PC version are identical. Only really difference is the barrel on the PC is 2 inches longer and has a tighter chamber. I have used CMC, Geissele, POF and Hyperfire PDI in my 15-22PC with great success. Never tried a Rise in it. I have used Rise 140...

They won't sell the part, say it's a restricted item. At least the two 1st tier reps I spoke with.

The page has been taken down, interesting.......

Yes, it works fine. It's a little slower than Mini mags solids but cycles fine. I'm finding Mini mags at the moment a little less expensive then AR tactical so I using that currently.