Recent content by Cooperd0g

$550 shipped to your FFL. Overall excellent condition Ruger SP101 with 4.2" barrel (model 5771) with fiber optic front sight and adjustable rear sights. Includes original box. Used, but probably just a few hundred rounds. Wolff spring kit installed which includes a reduced power trigger return...

Which 5 Star model do you have? I didn't see one for a 625 on their site.

Thank you, that is very helpful.

I am awaiting a new to me 625-6 in .45 Long Colt. So far the only speed loaders I can find that will work are the HKS 25-5. Are there any others?

Raven holster still available. Price drop to $50.

Bump to the top

Storm Lake 4.25" .40 to 9mm conversion barrel, excellent accuracy. $85 shipped. **SOLD** Raven Concealment Phantom holster for M&P 9/.40/.357 full size with 1.5" snap loops. $50 shipped. 3x OEM S&W M&P 9mm 17 round magazines. $20 each shipped. **SOLD** CAA MCK Gen 2 for M&P. $225 shipped...

First gen M&P .40 with original box, all three grip panels, 10-8 performance sights with fiber optic front, Apex Duty Carry Action Enhancement Kit (DCAEK) and two factory 15 round magazines. $400 shipped to your FFL. There is a break in one of the three metal cross holders of the fiber optic...

I had a similar realization about 8 years ago, but it was the Gen 4 Glock 19. Shot it better than my M&P first time out after quite a bit of time with my M&P with an Apex DKAEK trigger. Also happened to fit my hand better. Though recently I made the switch to the Sig P365XL for EDC.

What about asking them to send back the barrel and cylinder off your old gun along with the new 329PD? Then maybe you could have a local gunsmith do it?

The new Primary Arms Holosun 507C X2 and EGW mounting plate added 1.75 ounces to the empty weight. That will put the loaded weight just under 24 ounces. Though I am afraid I’ll have to trim the holster to accommodate.

It isn’t so much the guns themselves, but a lot of my optic mounts have specific torque settings. I did get the Chapman kit because the are hollow ground.

Okay, thanks. Maybe the better route is to just ensure I have the compatible bits for the FAT wrench too.

I bought a Chapman Tools gunsmithing kit, but unfortunately their bits don’t play well with my Wheeler FAT Wrench. Does anyone know of a good torque wrench that works well with the Chapman bits?

I'm not sure I even understand the question. If you have adjustable sights they have two screws holding the adjustable sight to the frame of the gun. Those holes are factory drilled and tapped. You just need to find a mounting place, or picatinny rail, that mounts to the preexisting holes and...