Recent content by DavidWin

I use the Armalaser TR4G ("G" denotes green laser) with my Shield 40. Very good fit and match, looks like part of the gun.

Holster for Shield with light and Laser Pyntek made me a holster for my Shield with a Armalaser TR4 try them.

ArmaLaser TR4 for S&W Shield 40 Ii have the ArmaLaser TR4 for my S&W Shield 40. It is an excellent fit and looks like part of the pistol, doesn't look like an add-on. The contact points work well, especially in conjunction with the Hogue Rubber Grip Sleeve (a beast to put on). The single finger...

I need IWB & OWB holsters for my Shield 40 with Armalaser TR4. Suggestions? Plus magazine holster.

Shooting left correction on the Shield Using a laser on my Shield revealed that at the trigger break the laser showed the aim point was jumping to the left slightly. Then I ran across this article: Free pistol shooting tips - ONE TWO method works The tip about rotating the right hand (I...

I have an ArmaLaser TR4G (green)that I extremely happy with, good reviews. Looks like part of the gun when installed. There are two contact plates that touch your middle finger when you grip the gun, laser comes on automatically. Also has a switch where you can turn the laser off for iron sight...

Apex Duty Carry kit installed Installed the Apex duty/carry trigger kit but replaced the flat trigger with my hinged trigger. Couldn't be happier.

Is anyone using an Apex flat trigger in combination with the Armalaser TR4G on the Shield 40? I am concerned whether there is enough space for the trigger to articulate after the Armalaser is attached to the trigger guard.

Just installed my APEX trigger kit in my Shield 40. Better trigger (zero creep, clean break) than my Sig Sauer P229 Enhanced Elite SRT with Gray Guns trigger and Custom Shop Action Enhancement Package. Only issue was I had to insert the seer assembly with the trigger bar before seating the...

I have a Shield 40, I want to install an Apex Trigger and AEK. Will that be a problem for getting approval in the concealed carry application process? What about a laser sight?