Recent content by DLWinner

I have one. It works. I shoot it pretty well for what it is.

I noticed there is a click right before the cylinder stop locks into the hole.

Hi! I recently picked up a used like new 442. I have shot it approximately 250 rounds and decided that I would like to install a WC Spring kit. I have installed lots of these in the past with no issues. I was wondering…. Is it possible to only change the hammer spring? Is it really necessary to...

I’m thinking it’s gotta be the trigger bar at this point. I will check it out later and replace with a non heavy version if needed. Are all of the heavy trigger bars stamped “H”? Thanks again!

I have a brinks issued Smith & Wesson M&P 40. It has a very heavy trigger. I’ve tried various Apex parts and I still cannot get the trigger correct. Does anyone know what parts are on the brinks that would need to be replaced? Is the trigger bar itself any different? Or the trigger housing?

I have an Azula OWB I bought on Ebay for $50. Great holster for the money.

Are the ones from Thailand decent quality? I have a set on my watch list now.

I have a model 57 classic. The grips on it look really nice but they are too small for my hand. Any suggestions for bigger. grips? Preferably wood, fatter, and under $100.

Wow. Did not know that about ammonia based cleaners. I think I cleaned mine once with Hoppes. I hope my finish will be ok.

For $30, it’s not a bad belt. Just not as still as I was hoping it would be.

I guess I’m just spoiled by the stiffness of my Ares Ranger enhanced.

After using mine for most of the day yesterday, I’m not impressed. I think it’s too flimsy to carry a gun comfortably all day. It was only $30 though.

I received my Azula leather holster yesterday. I am impressed. Comfortable, conceals well, and it was only $50. I will be ordering more.

Mine should arrive tomorrow. Can’t wait to try it out.

Pics? I need a holster for my 57.