Recent content by Dmacpro91

Make sure you are slowly pulling the trigger and keeping your sights on target the entire time. The shot should almost surprise you. This works great for me.

Cabela's has 525 Golden Bullets. Remington® .22 LR Rimfire Ammunition : Cabela's

Here is the cheap route that I took and it works great!! My little projects: Homemade Bump Fire Stock Jard 3 pound trigger works just fine.

Just out of curiosity is the front sight supposed to be facing that way? Edit: Or is it like that due to the lack of room in front of the main optic?

Here is some 60 grain subsonic if interested. Around 0.10 per round. Aguila SSS Sniper Subsonic Ammo 22 Long Rifle 60 Grain Lead Round Nose This looks like a very strange bullet though.

Tested it out today My girlfriend and I got to go out to the range today and finally test this thing out. Functions perfectly!! The Bushnell sight is incredible especially since it is under $100. Got a cheap spinner target from walmart and we went through probably 350 rounds of ammo. It was a...

It's the Bushnell TRS-25. ~$90 on amazon.

Small strips of electrical tape? (Just gotta get em inside the stock, that's the tricky-ish part.) I accidentally got the commercial moe stock a few days ago and mine was EXTREMELY tight on my 15-22 for some reason. Luckily I was able to return it and get the mil-spec though.

I used the crush washer with mine and it seems pretty solid. Just make sure the washer is facing the right way.

Done... for now Got a surprise in the mail today from tacticool22... Got everything assembled and it seems pretty solid. Will be testing everything this weekend. Thanks again everyone for all the help. :) Edit: My medium profile riser for the sight should be in tomorrow so hopefully then...

Link to delta ring assembly Here ya go: Delta Ring Assembly - AR15 Edit: As far as your second question I've only seen the A2 front sight post (sized to fit the 15-22) from True Shot Technologies, but no ~.65 gas blocks.

Just got off the phone with them myself and the lady just said that they are "still waiting and waiting and waiting and waiting". Must really suck to be one of their receptionists these days.

Hmm. Looks pretty interesting may have to pick one up when they get ready. Note: My grandmother shot my gun today and when she loaded her rounds she just pulled the load assist all the way down and loaded em up (no straight up bullets or anything go figure). Went through the entire "magazine"...

The width of each tooth is just under 2 tenths of an inch. Try not to make them too long as this will weaken them when you try to turn it. My wrench only uses 2 prongs since getting all 4 to line up was taking way too long. Also I flattened 2 sides on the opposite end to make it easier for a...

Yea I'll be home in an hour and a half. I'll give you images and measurements then.