Recent content by Doc498

Witch is the part number for the SSA-E ? Or what is the pin size? Thanks Doc498

The only Dumb Question is the one not ask!

After I removed the pin from the S&W stock I slid it on.

I am using the Troy 13.8  TRX 308 Extreme DPMS LP - BLK (STRX-E3D-13BT-00) with a Troy  .750 LP Gas Block.

I installed the Stock Mako GL-ShockCP Recoil-Reduching Stock.

I used a Troy  .750 LP Gas Block. If you don't have a DPMS tool take your M&P 10 to your local gun smith and have them change your barrel nut for you. And make sure the gas block is tight to the barrel flange. Make sure you use the Troy 13.8  TRX 308 Extreme DPMS LP - BLK (STRX-E3D-13BT-00).

I installed a Troy TRX 13.8 inch LP with a Troy LP gas block.

Redfield Counterstrike Tactical Riflescope 1X30 mm Red/Green  Dot Laser sight

Upgrade M&P10 Finished the upgrades (At this time) on my M&P10 New parts: Magpul MBUS Back-Up Sights Stock Mako GL-ShockCP Recoil-Reduching Stock Squid grips from Troy Troy 13.8  TRX 308 Extreme DPMS LP - BLK (STRX-E3D-13BT-00) Troy  .750 LP Gas Block Redfield Counterstrike Tactical Riflescope...

Pin Drilled Out I used a small bit and drilled from the pin side the pin was hollow. Than used a bit the same size as the pin to drill the stock than used a punch to drive the pin out.

Back from the range My first trip to the range with my M&P10. The new Mako stock worked good! I can shoot all day with this stock. I tried 6 steel DPMS mags all worked fine no drag marks on the brass. No miss feeds. The M&P10 is a good shooter. 20 rounds in a 5 inch circle at 70 yards with my...

GL-Shock Recived my GL-Shock stock today. And I must Say I like it. It is solid and tight as a tick. It took all of 30 seconds to install. I will post pic soon. Thanks H60sar!!

Will I drilled it out worked fine.

GL-Shock After looking at at the GL-Shock stock and the $ I ordered one from Cheeper Than Dirt. I had to drill out the role pin in my stock. It turned to be easer than I thought. I used a small drill bit and drilled through the pin to locate the other side then used a drill bit the same size...

I live in Texas but I picked up a compliment M&P 10. This is the frist time that I have had an AR sence my last trip to Nam. I liked the barrel better then the one with the flash hider. And my gun shop did not have the other model. So now to the help I need. What is the best way to remove the...