Recent content by Drifter Mike

These are N frame grips from Altamont I got for my 625 45acp as it came to me with rubbers. Got them for 30 bucks off e-bay and they were new!

Welcome from the East Central Florida! You will love it here!

That's the post number, here is the full thread: https://smith-wessonforum.com/threads/help-with-i-d-on-my-new-to-me-32-20-he.736899/#post-142184742

Here is the original post from when I got it: 142170520

It does in fact measure 6 1/2 inches!

I was gifted a S&W 625-7 Performance Center 5 inch in 45 acp that is lightly engraved. I do not know if it is a factory engrave or after market but is very nice! My question is, what would have been the original grips on it? Have a set of rubbers that would be good for shooting but I prefer to...

Yes I have, shoots like a charm and at 15 yds ( indoor range ) I could cover a cylinder full with a half dollar!

Picked up this a little while back and finally got around to requesting a letter. As can be seen, it left the East coast, went west to SF CA and then made it's way back to the So East coast ( Florida )! Not sure it is worth a deeper dive into it but it was a interesting find!

The true Oak Island treasure is the show it's self! They are making money hand over fist from the History Channel and that is the true treasure!

After thinking on it and with some encouragement from a friend, would getting a letter on this be worth the cost??

Yes the trigger has been checkered

Final 2 pictures Last 2 pictures. The ser# is 6406 the picture is upside down, my bad

More pics few mor pictures

Saw this at my local gun shop and just could not leave for home without it! 6 inch barrel with strong bore, cylinder chambers are nice and clean BUT it appears to have been re-finished at some point in the past and I do think the grips are reproduction are there are no markings on the inside (...

So, I am thinking I will rent a reamer and do the job myself. Thanks for all the input!