Engine49guy
- Messages
- 8,099
- Reaction score
- 9,170
Latest activity Postings About
-
-
Engine49guy replied to the thread Fishhook hammer.The S&W "High Speed" hammer aka the Fish hook hammer seems to dissappear by the introduction of the four screw frame, As with all things... -
Engine49guy replied to the thread Nickel 19-4 1978/79, Unfired since factory? What say you?.The pics are too blurry to be certain but doesn't appear to have the telltale case head imprints on the recoil shield, you will be able...
-
Engine49guy reacted to Redwood32R2's post in the thread Nickel 19-4 1978/79, Unfired since factory? What say you? with
Like.
The stocks are not modified and came with the gun. -
Engine49guy replied to the thread Nickel 19-4 1978/79, Unfired since factory? What say you?.I judge by the recoil shield, Need good clear pictures of that. The alternate burn marks on the cylinder are easily faked. Pics are...
-
First of all, there were no K-38s built in 1946. The first was assembled in June 1947, and none of them shipped until February 1948...
-
Engine49guy replied to the thread 5 Screw .38 Pre-15 CM stocks with unusual notch.A few thoughts, Early non releived target stocks were usually relieved inside just in front above the strain screw. Iirc it wasnt the...
-
Engine49guy replied to the thread Is anyone out there still able to convert a Model 28 to 44 Special?.If the new 686 Mountain gun is also a 7 shot than even though its L frame cylinder is larger IIRC because of the 7th hole and narrow rib...
-
Engine49guy reacted to Muley Gil's post in the thread Is anyone out there still able to convert a Model 28 to 44 Special? with Like.
The M629 is an N frame and the M686 is a L frame. N frames are larger, as are the cylinders.
-
While I'm not thrilled to, now, own all of Dad's guns, I am trying to enjoy them a little at a time. A recent thread reminded me of the...
-
-
I know, late to the party. I didn’t want to open up a new chapter - and my wallet so I resisted all along. But… to round out my 4 screw...
-
Engine49guy replied to the thread Model 66 no dash locking-up due to heat expansion of Gas Ring?.I recently had a chance to dig into this topic deeper, all my k frames have the gas ring on the cylinder until late 1975 so perhaps an...
-
Engine49guy replied to the thread S&W 66 history (additional detail)? Sights and gas ring.I only own one K frame with the gas ring on the yoke, it is Serial 6k94157 (according to SCSW is from 1975) if anyone has one close with...
-
Engine49guy replied to the thread 1960s S&W Model 60 Evolution.How did I miss this thread 3 years ago? All I have is a story of the one that got away, was at at the WPB gunshow many years ago saw an...
-
I called S&W last week to look up a vin. I could probably be wrong but I think 69 ended 786xxx area theres one for sale right now
-
-
Loading…
-
Loading…