G

GraMott

Member
Joined
Last seen
Messages
11
Reaction score
8

Latest activity Postings About

    • G
      GraMott replied to the thread Testing for yoke endshake.
      Thank you very much!
    • G
      GraMott reacted to armorer951's post in the thread Testing for yoke endshake with Like Like.
      These tolerances, end shake cylinder and end shake yoke, are checked with the yoke screw in place. Carter
    • G
      GraMott posted the thread Testing for yoke endshake in S&W-Smithing.
      When testing for yoke endshake, do you reinstall the yoke screw or test without it? There is a video from Power Custom where he is...
    • G
      GraMott reacted to RebCop's post in the thread 19-3 is toast? with Like Like.
      I had a custom M-28 in .44 mag. that had the same problem. Cylinder and crane shims made it tight as a drum and no further problems.
    • G
      GraMott replied to the thread 19-3 is toast?.
      That's good to hear. Looking forward to the bearings arriving so I can see the results.
    • G
      GraMott reacted to armorer951's post in the thread 19-3 is toast? with Like Like.
      Yes, you're correct. End shake can cause the opening/closing issues you're experiencing. Excessive end shake causes the cylinder...
    • G
      GraMott reacted to stansdds's post in the thread 19-3 is toast? with Like Like.
      End shake of 0.010" is well beyond maximum acceptable. End shake is most often caused by the cylinder pounding against the cylinder...
    • G
      GraMott reacted to armorer951's post in the thread 19-3 is toast? with Like Like.
      The existing barrel cylinder gap (front gauge) and the headspace (rear gauge) are measured with the cylinder closed and "at rest"....or...
    • G
      GraMott reacted to toad67's post in the thread 19-3 is toast? with Like Like.
      IIRC, Carter, a member has to have 25 posts before they can post in the classifieds. However, I read thru the rules and it doesn't...
    • G
      GraMott replied to the thread 19-3 is toast?.
      Thank you very much for the assistance. I will try the bearings once they arrive and see if that solves the cylinder issue...
    • G
      GraMott replied to the thread 19-3 is toast?.
      When I sent the revolver in to Smith for a new front sight and new yoke screw, I requested that they examine the gun and relay any...
    • G
      GraMott posted the thread 19-3 is toast? in S&W-Smithing.
      I have a 19-3 that went back to Smith two years ago for some sight work and I had them replace/fit a buggered yoke screw. I have had...
    Show older items
  • Loading…
  • Loading…
Back
Top